New
Bambu Lab PTFE Tube P1S/X1C Series
€5.69 Inc. VAT
Bambu Lab PTFE Tube Coupler P1P/P1S Series
€6.99 Inc. VAT
Bambu Lab PTFE Tube Connector X1/P1 Series
€8.99 Inc. VAT
The PTFE Tube Connector (without holder) is a component used to connect the PTFE tube, which is mounted on the back of the printer and used to connect the PTFE tube between the buffer and the tool head.
In the Box: 3 pieces
4 in stock
Compatibility
X1/P1 Series
Installation
Learn more about the replacement of the PTFE Tube Connector (w/ holder) on Bambu Lab Wiki
Instructions for use
1. The PTFE Tube Connector is designed with a clear direction of use, as shown in the figure below. Connect the PTFE tube from the buffer output to the IN end, and the PTFE tube from the tool head to the OUT end. It is important to note that reverse connections may cause material blockage, so it is essential to ensure that the installation direction is correct.
2. When AMS is not being used, it is necessary to remove the feed tube connector from the OUT end, disconnect the connection between the feed tube connector and the PTFE tube of the tool head, and directly insert the consumable material wire into the PTFE tube of the tool head.
