Bambu Dual-Sided Textured PEI Plate
€44.90 Inc. VAT
The Bambu Dual-sided Textured PEI Plate is a flexible magnetic build plate with sprayed dual-sided PEI coating. During printing, the plate will provide excellent adhesion and easy print removal after cooling.
10 in stock
Recommended Settings
Please note that other slicer settings might need to be adjusted based on the printed model and the filament requirements
| Hotbed | Temperature | Glue Stick Required | Upper Glass Cover Plate Removed |
| PLA/PLA-CF/PLA-GF | 45~60℃ | No | Yes |
| ABS | 90~100℃ | No | No |
| PETG | 60~80℃ | No | No |
| TPU | 35~45℃ | Yes | Yes |
| ASA | 90~100℃ | No | No |
| PVA | 45~60℃ | No | Yes |
| PC/PC-CF | 90~110℃ | Yes | No |
| PA/PA-CF/PAHT-CF | 90~110℃ | Yes | No |
Surface Finish
The Bambu Dual-sided Textured PEI Plate uses sprayed PEI to provide a tactile matte surface to areas of the model that touch the build plate
Pros
Dual-sided textured PEI for increased surface lifetime
Most of the time, no glue-stick is required for regular filaments
Nice textured finish for the prints
Excellent adhesion and easy print removal
Cons
Glue-stick is still recommended for some filaments and printing conditions
Cannot be used without heating the printing surface
LIDAR will have trouble correctly reading the print surface and the calibration can be affected
Product Specification
| Surface temperature resistance | Up to 200℃ | Usable print size | 256*256 mm |
| Flexible spring steel thickness | 0.4 mm | Texture PEI coating thickness | 0.075 mm |
| Package Weight | 320 g | Package size | 290*290*4 mm |
Considerations
-When printing filament with a heat deflection temperature below 60℃ (such as PLA, PVA, TPU) the hotbed temperature is set above 45℃ and it is recommended to open the front glass door and remove the upper glass cover plate to avoid heat creep that can cause the material to soften, leading to abnormal extrusion or clogs
-The Automatic Calibration for Flow Rate is not recommended, as the LIDAR will have trouble correctly reading the print surface and the calibration can be affected
-Regularly clean the print surface with dish soap and hot water to eliminate any dust or grease residue, which might cause bad adhesion
-Do not clean the Textured PEI with Acetone, as it might damage the PEI surface
-Always wait for a few minutes before removing printed models to allow them to cool down for easy print removal